PT

Answers · The symptom: The piece comes back because the color was wrong

The piece came back because the color was wrong. How do you avoid it?

Move the check to before you send — four points whoever makes the piece can run in two minutes.

Open the free tool

The piece comes back because the check happens at the end, with whoever approves, and not at the start, with whoever makes it. By the time the mistake is found the work is already finished — and redoing it costs twice what checking would have.

Why the mistake only surfaces at the end

  • Whoever makes it has no criterion at hand. The rule is in the manual, and the manual is somewhere else. The piece gets made with the color that looked right.
  • Whoever approves looks at the whole. An approving eye is about aesthetics and message; a color error slips under it and shows up later, often in print.
  • "Close enough" gets through. With no code alongside, nobody compares values — they compare impressions. And two colors that sit close on screen can be visibly different on paper.

The four points, before you send

  1. The codes. Compare the value you used against the one the manual declares, not by eye. Brennimark Colors is free, runs in your browser and returns HEX, RGB, HSB and CMYK for any color you measure in the piece.
  2. The logo version. Horizontal, vertical or symbol, and positive or negative depending on the background. It is the most common mistake after color.
  3. The minimum clear space. The free space around the logo that the manual declares. Nobody measures it, and it is the most visible failure.
  4. Legibility. In the contrast tab of Colors, check the contrast ratio and the verdict under the WCAG standard, plus how the piece looks to someone with color blindness. An approved color can still be unreadable under the text you chose to put on it.

Two mistakes that send the piece back again

  • Checking on screen only. A monitor and paper do not show the same color. For printed pieces, what counts is the manual's CMYK or the printer's proof — automatic conversion is an approximation.
  • Checking only at the end. If the check stays the job of whoever approves, the rework stays too; it only changes name. The four points above belong to whoever makes the piece.

How rework stops being routine

The check has to sit where the piece is made, and be backed by the brand's own rule — not by general design knowledge.

At Brennimark Vini Max gives the piece a second reading against that brand's manual: you send the image, choose what to check, and it answers citing the page each rule came from. When the guideline is not documented, it says it is not instead of filling in with what tends to be true at other brands. The decision stays yours — what changes is that it becomes an informed one before you send, not after the rejection.

See which brand color is the right one or Vini Max.

Is your case a different one? Talk to us.

Talk to support

Let us show you Brennimark at work.

Write to the sales team. We'll set up a demo with you, in person at your agency or by video.

‹sales email to be defined›

Prototype: the contact address doesn't exist yet.